ADVANTAGES
• – Compact, ergonomic unit means smaller footprint on factory floor
• – Wide range of choice thanks to modular solutions
• – Process reliability and energy saving for high-quality finished products at a lower cost
• – Easy to use and maintain
• – User-friendly control panel
OPTIONS
• – Table extension, for longer calibration
• – Motor-driven transversal adjustment
• – Tilting of calibrator plane ± 5 mm
• – Additional water and vacuum distributors
• – Additional vacuum pump
• – Feed pump and discharge pump with cyclone
• – Energy saving via inverter
• – Profile blow dryer 2.2 kW
• – Closed loop water system
• – Heat exchanger
• – Set of saddle flowmeters
Omnia can also be used for the extrusion of pipes up to Ø 63 mm by mounting our sizing tank on the calibration table.
The quick-change pads allow the user to fit different types of rubber or contoured pads or to carry out maintenance with a generous time saving.
COMBO POSSIBILITIES
• – OP-C/H: puller-horizontal guillotine cutting unit
• – OP-C/V: puller-vertical guillotine cutting unit
• – OP-C/D: puller-cutting saw
Type : for tubes, profile
Treated material : for thermoplastics
Other characteristics : compact
Reviews
There are no reviews yet.