Automatic Specimen Mounting Press
Technical Specifications
Standart mold assembly: 1″ – 1,25″ – 1,5″ – 2″ (mm Ø 25, Ø 30, Ø 40, Ø 50)
Machine dimension: 45x57x64 cm
Case dimension: 65x70x70 cm
Weight (net/gross): 70/100 kg
Mains: 220V, 50Hz
Mold heater capacity: 12050 WattMax.
Hydraulic system pressure: 250 bar
Entering heating,cooling & preheating values
Manual cooling,alarm indicator for cycle completion
Manual rasing and lowering piston by motor when required
Full automic cycle until sampling finalised
Fast & easy operation for inserting the sample and power as well extracting mold
Standart Accessories
Mold assembly 1
Phenolic powder 1
Pipe for water source 1
1) – Temperature: Required temperature settled temp.value (°C)
2) – Waiting time: Waiting time in required settled temperature (min.)
3) – Cooling set: Required cooling settled temp.value (°C)
4) – Pre-heat set: Temperature when machine is on. (°C), but not functioned.
5) – Pressure set: Adjustment of max.pressure required (Bar)
Recommended pressure between 150-200 bars depending on sample. (Max. applicable pressure is 250 Bars) Entering required values on Digital Panel (see screens step by step)
Operation
Remove the mold locking system by turning the mold locking lever in the clockwise direction.
Other characteristics : automatic, for metallographic samples, hydraulic
Reviews
There are no reviews yet.